Minnie Mouse Straw decor…..

I used my Cameo Silhouette 3 but you can just cut out the templates by hand if needed. As a newbie I must say it took me a few attempts to get the design right. But using my Cameo Silhouette made this so much easier.

Depending on your design you may need to adjust your settings so I recommend cutting one at a time until everything fits perfectly.

This is the template I made on the Cameo Silhouette software. The Minnie outline is about 2×2″ and the cut lines inside Minnie are about 1.5cm’s. Minnie’s bow is 1 inch long and about 2cm’s in height. For Silhouette users, The blue line represents what the scketch pen will draw in and the red lines will be cut.

The first set of ears and bows I made were too small to fit in the straw so I had to go bigger. This is why I recommend making one at a time and make sure the cuts will fit the straw your using before you make a lot of Minnie ears. Then proceed with the bow. If using computer software, all you have to do is stretch out the designs until they fit with what your working with.

This template can also be used for cupcake toppers using a toothpick. You will just need to decrease the cut lines inside of the Minnie template. Good luck on your creations!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.